|
Hey everyone. I've bought a Foscam IP camera, configured it, and see it on my network. I have U-Verse and I've checked all the internal settings... I've done everything I can think of on this. I'm using port 3389 (open port tested OK) however when I set up my http://dyndns.tv host, it sees it but I cannot access it. Here is the report I get... ;; ANSWER SECTION: http://mikesha.dyndns.tv. 60 IN A 99.101.*. (Stars are there on purpose, I checked and it is my current IP) Any Suggestions? Thanks |
|
Ok.. I think I have figured out a large issue with this.. A while back, I forwarded port 3389 for my desktop PC for remoting in. I didn't realize this until I was trying to assign that port to the camera. IT seems to work for the most part now.. So... If I close the question and answer it myself, do I get points? :/ – mikesha032 0 secs ago |
|
also have ddns problems with setup of A foscam... works fine as wireless but can not get it send using dynds new to dynds and would like some advice about all the settings So, rather than posing your question as an answer to somebody else's question, please ask your own.
May 26 at 08:04 PM
Cry Havok ♦
|
